Description
Features:The white wire is a 100K thermistor, and the red wire is a 24V 40W heating rod. The blue high temperature resistant PTFE tube is about 0.6M long and fits 1.75mm.
Material: aluminum alloy
Size: 0.4/1.75mm
Voltage: 24V 40W
Working temperature: -20 ~ +260?
Lead length: 0.6M
PTEF tube length: 0.5M
Applies to: Creality 3D CR10-V2
Replacement method:
1. Disassemble the hood (the fixing screw of the hood is behind the back plate of the extruder)
2. After removing the hood, there are three fixing screws on the back of the hood, loosen and remove
3. Remove the old hot end kit, and unplug the old cable from the network management system. (The position of the hot end adapter plate is at the right rear of the extrusion mechanism)
4. First plug in the new hot-end kit section, turn it on to check the temperature and whether the heating is normal. If it is normal, install the wind hood according to the previous steps. If it shows abnormal temperature detection, loosen the screw fixing the thermistor on the heating block. You can return to normal.
Package Included:
1 x Hotend Extruder Kit
?
