ADO A16 A26 A20 A20F 350W/500W Ebike DC Motor Controller Rear light Reflector Electric Bicycle Replacement Parts – #2

Specification:
Rated voltage
36V
Limit current
15A±1A
Overvoltage protection
64V
Matching motor
350W:A16, A20
500W: A20F, A26
Overcurrent protection time
2.5mS
Average driving current
7A±1A
Throttle voltage
0.8-3.7V
Undervoltage protection
30V
Matching models
#1: A16, #2: A20, #3: A20F, #4: A26
Size
93x55x30mm

Taillight installation Guide:
1.Clip the new taillight bracket to the seat tube. And tighten the screws.
2. Align the tail light with the bracket and snap it into the clip.
3.Unplug the isolation tape. Use the light through the switch button at the bottom of the light.
4.The front and rear shells of the lamp can be opened through the separation film position, and the AAA battery of the lamp can be replaced.

Steps to Replace the Controller:
1. First arrange the cable of the new controller in order.
2. Open the control box of the bicycle, take out the old controller and some wires.
3. Organize the order of the old controllers and cables.
4. In the order of the above chart. Disconnect the No. I cable (motor power cable) of the old controller. Connect the No. I cable (motor power cable) to the new controller according to the color.
5. In the order of the above chart. Disconnect the No. 2 cable (motor hall cable) of the old controller. Connect the No. 2 cable (motor hall cable) to the new controller.
6. Follow the above method. Transfer 1 cable from the old controller to the new controller every time.
7. After completing the transfer of these 11 cables. Put the new controller into the control box first. Put the cable on the controller.
8. Lock back the battery terminal board (note the direction it is connected to the battery) 0 Complete the replacement of the controller.

Package included:
1 x 350W/500W DC Motor Controller
1 x Rear Light
1 x Reflector
1 x Accessories Set