Description
1) Latest KKmulticopter controller V5.5 Board,V2.1 program2) Simple structure, Easy to Maintain and Debug Control
3) Relying on potentiometer adjust gyro sensitivity.
4) Full servo signal output, support normal ESC / analog servo
5) Support for single-axis / UFO, Y3 3-axis, Y4-type 3-axis, 4 axis, 6 axis, V22 flight mode
6) Supports 4-axis "+" and "X" flight mode, support for six-axis "HEXA6" and "Y6" flight mode.
* Setting up the kkMultiCopter controller
1) Setting transmitter channels
2) Stick Centering
3) ESC throttle calibration and Battery type
4) Gyro(Servo) direction reversing (Optional)
5) Clear all settings [servo & stick centering] (Optional)
6) Setting Gyro gain
7) Setting flying mode by Transmitter
* Stick Centering
Now we offer two ways to do "Stick Centering".
The First is using Transmitter which is similar to Setting flying mode.
As following the picture on "7. Setting flying mode by Transmitter", Stick Centering becomes very Simple.
This is same way to set the Flycam NaviBoard.
1) During Throttle Stick is down position, Down the Elevator Stick for 3 seconds.
2) Then Led lights will keep blinking.
3) Release all sticks. then led will stop blinking.
4) Now Processing Stick Centering. plz just keep position of all Sticks.
5) After complete "Stick Centering" , The Led will Blink once.
All procedure is finished.
The Second is using gain port.
We provide convenient method to set multicopter.
Your current stick position can be center by following next steps except throttle
