Sale!

NS191 Switch bluetooth Handle Mini Gamepad Dual Turbo Burst Gaming Joystick with Screen Shot Vibration – Blue red

Original price was: $200,51.Current price is: $148,88.

2000 in stock

SKU: 1767917BANG Category:

Description

For the first connection and pairing, please follow the steps below:1. Turn on the Switch host2. Install the handle on the Switch host and use the slide on the side of the host to slide the handle from top to bottom until you hear a slight click3. The handle starts to automatically register and pair. After the pairing is successful, it can be plugged in and used on the host or removed
Connect and use via Bluetooth:After the controller is installed on the host, the pairing cannot be registered, please refer to the following methods to check the pairing problem:1. Make sure your host has been upgraded to the latest system2.Press the pairing button to close the handle, reset the connection of the handle, and then plug the handle into the host3. Insert the handle into the host, make sure the direction of insertion is correct, it slides to the end, and a slight click sound is heard4. Unplug the handle from the host, try to insert it again, and rule out that it cannot be paired because there is no good contact5. If the handle cannot be awakened, please charge your handle before trying to pair
Note:1. The switch host must be in the on state, if the host is in the dormant or off state, the handle cannot be paired2. When the handle cannot be awakened or the LED indicator continues to flash slowly, please charge your handle before using it
How to pair (connect back) the controller to the switch host again:After the handle is paired for the first time, the handle can be connected to the host again in the following two waysMethod 1 Bluetooth connection and pairing1. Turn on the Switch host2. Press any function key (except the joystick) for 2 seconds to wake up the handle, and then the handle will automatically andThe host connects back to the pair via Bluetooth, and the back-to-back pairing can be completed in about 4 seconds3. Once the pairing is successful, the corresponding LED indicator of the handle will be on
Method 2 Wired connection pairing:1. Turn on the Switch host2, Attach the handle to the host through the slide on the side of the host3. After that, the handle will automatically pair with the host through a wired connection, which can be completed in about 4 secondsConnect back to match
Pairing question answer:When the handle is inserted into the host, it cannot be paired, please refer to the following method to check the paired handle or methodMethod 1: Delete the pairing information of the Switch host1. On the main interface, select [Settings], then click [Handle and Sensor], and select [Disconnect the handle]2. Long press the X button of the handle to disconnect the host from all handles and release the matching3. Pair all the handles that need to be used againMethod 2: Press the pairing button of the handle, reset the handle connection, and pair againRemove the handle from the host, press the pairing button of the handle, reset the connection of the handle, and pair the handle to the host againMethod 3: Ensure that the handle has been slid into the slideway of the host in the correct way, and slide the handle to the endMethod 4: Charge your handle, because the battery of the handle must be in a low battery during transportationWhen you get the handle, the handle may be in a low power state and cannot be turned onMethod 5: Make sure the host is the latest systemMethod 6: Try to remove the handle from the host and connect again