Description
Shipping List:- Motherboard only.
Spider V2.2 motherboard*1 - Spider motherboard + 2209 + 5160 driver kit.
Spider V2.2 motherboard*1
2209 V3.1 driver*6
HV5160 high voltage driver*2 - Spider motherboard+2209+pt100 temperature measurement module.
Spider V2.2 motherboard*1
2209 V3.1*7
PT100 temperature measurement module*1 - Spider motherboard + special screen kit.
Spider V2.2 motherboard*1
Spider V2.2 motherboard special screen *1
Introduction:
SPIDER is a small but powerful 3D printer control board. In a limited space, it integrates 8 stepper motor drives, 5A 12V power supply, 8A 5V power supply, which provides powerful energy for fans of various voltages, various RGB light strips and Raspberry Pi. You can build a 3D printer with rich functions through SPIDER. Especially for VORON V2.4, we cooperated with the VORON team in the early stage of design, and many features have been recognized by the VORON team. If you are building VORON, this will be your best choice.
If you want to know more info about product. you can click to open this link?https://github.com/FYSETC/FYSETC-SPIDER
Features:
- Compact size: 155.3mm x 76.5mm
- Based on STM32F446 180Mhz?all IOs can withstand 5V voltage
- 8 TMC stepper drivers support, with Uart&SPI support
- V2.2?Add Two 60V-Max stepper driver slot
- Improved TMC jumper settings again?simpler and easier
- V1.0&V1.1: 28V input max?12V@5A DC-DC?5V@8A DC-DC (Especially for Raspberry Pi)?3.3V@0.8A LDO
- V2.2: 28V input max?12V@3A DC-DC?5V@5A DC-DC for Raspberry?5V@3A DC-DC for mcu and RGB, Two 3.3V@0.8A LDO for MCU and motors
- Two car fuses for hot bed input and main power input
- Limit switch socket 24V/5V/3.3V optional, ready for more other equipment, such as -inductive sensor, BL-Touch
- XH2.54 connectors
- 10x PWM capable power mosfet outputs (1 for HotBed, 3 for Heat-End, 3 for fans, 3 for RGB LED strip)
- V1.0&V1.1: 3pin temperature header, you can use thermistor or thermocouple (requires AD597 module)
- V2.2: Up to 6 temperature sensors support
- Up to 8 ways PWM fans (only use 1 extrueder and no 12V/24V RGB used )?2 ways RGB led(12V & 24V optional) ?1 way 5V-RGB led (NEO-PIXEL/WS2812)
- RepRapDiscount SmartController compatible pin header on board
- UART1-Raspberry Pi pin header (including 5V@8A power supply)
- 2X4 PinHeader Out for SD Card moudle
- Onboard micro-SD card
- Type-C and Type-B USB connector optional
- EXP1 & EXP2 have more multiplexing functions, such as USART, I2C, CAN
- SD card & USB upload support
- A 4.7kOhm 0.1% temperature sensor pull up resistor is used, PT1000 can be connected directly. For PT100, an amplifier board must be used.
- V2.2: Add more protection (TVS for each motor divers, current limit resistor, VMOT fuse)
